(For a single band on only the IC-7851, 78)
Remotely Control Icom Transceivers through an IP Network …įor more information about the IC-7300 visit: …īoth the RC-28 IP Remote Control System and IC-7300 are both available from all authorised Icom Dealers. The RC-28 IP Remote Control System, allows Radio Amateurs to remotely operate selected Icom amateur transceivers. To found out more visit the RC-28 IP Remote Control System page where you will also find a list of compatible Icom HF radios. Introduction to the RC-28 remote controller encoder.Setting up a USB connected station is pretty straightforward, but operating wirelessly, with the exception of your antenna, takes a little more preparation, and maybe the purchase of some additional Icom software, namely the RS-BA1.
Installing the RS-BA1 remote control software Going portable can take a bit of effort, so the fewer cables you have to lug around, the better.The video shows Bob McCreadie (G0FGX) of TX Films demonstrating: Our friends at the TX Factor have produced a video that logically goes through the step by set process of remote controlling an Icom Amateur radio, more specifically in this case, the IC-7300 using the RS-BA1 remote control software.